After getting the swing arm powder coated I wanted to get it back on to the bike could get back on its wheels and I could have a shuffle about.
First thing was to get the main bearings (4) back in to the pivot, these are super snug so lots of grease is needed. TIP, place the bearings (4) in a freezer for 10 minutes then install them in to the swing arm. The cold will make the bearing contract a little and make installing them a little easier. Fit the O-rings (7) to each side of the roller bearing and grease liberally. At this point I put the pins also (5) in the freezer to shrink a little while the roller bearings expanded to their normal size. Next I just slid the pins (5) in the bearings (4), easy!
Next I installed the bearing shields (3) to each end, again with grease so they wouldn't easily drop off.
The next stage was to offer up the swing arm to the main frame and slide the main pivot axle (2) in to hold it there.
The next stage was to get the rear shock and the shock linkage fitted. The shock can go in via the top or bottom but you will have to raise and lower the swig arm at points to get every bolt it. Again grease all bearings, and plenty of it.
I re-fitted the rear hub then re-fitted the wheel to be able to move the bike around but it will need to come off again for power coating.
Note, the wheel has a boss (1) on it which mates to a cut out on the rear wheel, make sure you do this.
Lastly I fitted the chain slider.
Torque values.
The workshop manual states torque values in daN.m- Dekanewton, where the more common values now are in Nm - Newton, the conversion is just one decimal point or x 10 for ease, I have included both.
Shock linkage bolts including the top shock mount (fig 88 + 89) = 5 daN.m or 50Nm
Main pivot = see fig.92 follow correct procedure:
- Complete unscrew the adjustment boss on the right hand side (3)
- Insert the pivot axle and screw it in a few turns
- Screw the adjustment boss (3) and torque to 1 daN.m or 10Nm
- Tighten the retaining lock nut (1) in using the notched Aprilia tool to 2.5 daN.m or 25Nm
- Tighten the main pivot axle to 8 daN.m or 80Nm
Wheel nuts = 8 daN.m = 80Nm
Main axle shaft nut (fig91, part 4) = 8 daN.m or 80Nm
![]() |
this nut is torque to 80Nm, which may require an extension bar... |
![]() |
main pivot requires a procedure to correctly tighten. |
No comments:
Post a Comment